AN MD11 WAS DISPATCHED IN NON COMPLIANCE WITH THE #1 ENG THRUST REVERSER LOCKED IN THE FORWARD THRUST POS.

Narrative

I WAS LEAD MECH ON ACFT. DURING MAINT; REVERSER WAS PINNED. NO LOG ENTRY WAS MADE AND NO ONE WAS INFORMED AT TURNOVER. I RELEASED THE ACFT FOR SVC WHICH MADE AN AIR TURN-BACK BECAUSE A PAX NOTICED A PANEL FLAPPING ON #1 PYLON. ON ARR AT THE GATE; THE REVERSER PIN WAS FOUND INSTALLED. CALLBACK CONVERSATION WITH RPTR REVEALED THE FOLLOWING INFO: THE RPTR STATED THE YOUNG MAN WHO INSTALLED THE LOCKOUT PIN WAS REALLY FOLLOWING THE PROCS USED ON THE LOCKHEED L1011 WHERE ANY ENG WORK REQUIRES PINNING THE THRUST REVERSERS. THE RPTR SAID THE PANEL USED FOR ACCESS TO INSTALL THE LOCKOUT PIN IS 2 INCHES BY 4 INCHES AND IS LOCATED IN THE LEADING EDGE OF THE PYLON AND WILL CLOSE FLUSH TO THE PYLON SKIN AFTER THE LOCKOUT PIN IS INSTALLED. THE RPTR SAID AFTER THE LOCKOUT PIN IS INSTALLED AND THE DOOR FLAPS CLOSED; THERE IS NO WAY A VISUAL CHK FROM THE GND WILL DETERMINE THE STATUS OF THE REVERSER. THE RPTR STATED THE LOCKOUT PIN HAS NO STREAMER ATTACHED AS IT IS STORED IN THE SAME 3 INCH BY 4 INCH COMPARTMENT AND IN A HIGH HEAT AREA. THE RPTR SAID THIS TYPE OF INCIDENT HAS HAPPENED BEFORE AND THE COMPANY IS IN THE PROCESS OF CHANGING THE JOB CARDS. THE RPTR SAID THE TECHNICIAN WHO INSTALLED THE PIN CANNOT BE EXCUSED FOR NOT MAKING A WRITE-UP THAT THE PIN WAS INSTALLED.