AN EMB140 IN HVY MAINT HAD MINOR PAINT REPAIRS TO ELEVATOR SURFACES WITHOUT REMOVAL OF ELEVATOR. TECHNICIAN RPTS THEY ARE NOW REQUIRED TO REMOVE ELEVATORS FOR MINOR PAINT REPAIRS.

Narrative

DURING HVY MAINT INSPECTIONS; I HAVE REPAIRED THE FINISH (PAINT) ON THE ELEVATOR. MINOR IN NATURE USING THE COMPANY PROC MANUAL. HOWEVER JUST THIS WEEK MY SUPVR INSTRUCTED ME TO REMOVE BOTH THE L AND R ELEVATOR BECAUSE IT HAD SIMILAR TOUCH UP PAINT REPAIRS THAT NEEDED TO BE ACCOMPLISHED AND THEREFORE NEEDED TO BE STATICALLY BALANCED AS STATED IN THE EMB140 AMM AND THAT STATES IN STEP 1A; 'THIS SECTION GIVES THE NECESSARY PROCS TO DO THE STATIC BALANCING OF THE L AND R ELEVATORS AFTER A REWORK; REPAIR OR PAINTING OF THE ELEVATOR AND OR OF THE SPRING TAB.' MY CONCERN IS; THAT WITH THE REPAIR ON THE ELEVATOR PANELS WHETHER IT IS PAINT OR COMPOSITE REPAIRS; HAVE I NOT BEEN FOLLOWING MAINT PROCS BY NOT REMOVING THE ELEVATOR AND PERFORMING A STATIC BAL TO THE ELEVATOR BY INSTALLING A REPAIRED PANEL OR BY TOUCHING UP PAINT ON THE ELEVATOR. I HAVE SPOKEN WITH SEVERAL MECHS ON THIS ISSUE AND IT APPEARS THAT THEY PERFORM THE SAME TASKS IN THE SAME MANNER AS I DO. AND I HAVE BEEN DOING THESE HVY CHKS FOR ABOUT 2-3 YRS. SO I DO BELIEVE THAT IT IS OUR MAINT BASE AS A WHOLE THAT MAY BE AT FAULT HERE AND FOR SOME TIME. THIS IS A PROB WITH ONLY THE ELEVATORS THAT WERE NOT REMOVED FROM THE ACFT. CALLBACK CONVERSATION WITH RPTR REVEALED THE FOLLOWING INFO: THE PROB IS NOBODY BOTHERED ABOUT THE MINOR PAINT REPAIRS ACCOMPLISHED DURING THE HVY MAINT CHKS UNTIL SOMEONE LOOKED FOR THE ALLOWABLE LIMITS IN THE EMBRAER 140 STRUCTURAL REPAIR MANUAL AND FOUND NOTHING. THE REACTION WAS IMMEDIATE AND ANY MINOR PAINT REPAIR REQUIRED L AND R ELEVATOR REMOVAL AND ROUTING THROUGH THE FLT CTL SHOP FOR MINOR PAINT REPAIR AND REBALANCING. THE PROB HAS BEEN KICKED UPSTAIRS TO ENGINEERING AND THE MANUFACTURERS LEVEL BUT STILL NO MANUAL REVISION FOR ALLOWABLE PAINT REPAIR LIMITS WITHOUT REBALANCING.