RPTR AND FELLOW MECH INSTALL DC9 WHEEL ASSEMBLY ON MD80.

Narrative

ON THE REMAIN OVERNIGHT OF NOV/XX/95; 2 DC9 TYPE NOSEWHEELS WERE INSTALLED INADVERTENTLY ON AN MD80 ACFT. WE HAD A VERY BUSY NIGHT. A HVY WORKLOAD. IN AN ATTEMPT TO ASSIST THE MECHS WORKING ON THE REMAIN OVERNIGHT ACFT; THE LEAD MECH; C; DELIVERED 2 NOSEWHEELS. THE MECHS; A AND B INSTALLED THEM ON THE ACFT. IT WASN'T NOTICED UNTIL AFTER THE ACFT HAD DEPARTED FOR LGA. THE STOCK CLERK NOTICED THE PART NUMBER ERROR. LGA MAINT WAS CONTACTED IMMEDIATELY AND ADVISED TO REPLACE THE NOSEWHEELS WITH THE PROPER TYPE WHEN THE ACFT ARRIVED. THE NOSEWHEELS WERE REPLACED AT LGA. THE SUPVR AND REGIONAL MGR WERE BOTH NOTIFIED. IT WAS AGREED THAT AN ERROR HAD OCCURRED BUT WAS IMMEDIATELY DEALT WITH. ALL INVOLVED WERE VERY CONCERNED AND TOOK THE NECESSARY STEPS TO CORRECT THE SIT WITHOUT DELAY. THE ENTIRE MAINT DEPT AT SYRACUSE WAS BRIEFED ON WHAT HAD HAPPENED AND ALL ARE WELL AWARE TO DOUBLE-CHK WHEEL PART NUMBERS BEFORE INSTALLING THEM ON THE ACFT. NOTE: THE WHEELS ARE MARKED FOR ACFT TYPE BY THE VALVE STEM; BUT THE VALVE STEM IS ROTATED TO THE TOP FOR SVCING ONCE THEY ARE INSTALLED. THE ACFT TYPE MARKING IS NOT READILY VISIBLE WITH THE VALVES THUS POSITIONED. CALLBACK CONVERSATION WITH RPTR REVEALED THE FOLLOWING INFO: THE RPTR STATED THE DC9 NOSEWHEEL ASSEMBLY DASH 5 AND LATER IS APPROVED FOR THE MD80 BY THE MANUFACTURER AND FAA. THE ACR DOES NOT AUTH THE INTERCHANGE. THE TIRE PRESSURE AND THE FUSE PLUG TEMPS ARE DIFFERENT. THE WHEEL ASSEMBLY WAS A DASH 6. SO NO HAZARD EXISTED. THE RPTR SAID THE FAA FELT THE RPTR SHOULD SUFFER A LETTER IN HIS FAA FILE FOR 2 YRS FOR NOT ASSURING THE APPROPRIATE ASSEMBLY WAS INSTALLED ON THE MD80. SINCE THE RPTR SIGNED THE LOGBOOK; HE AND ONLY HE RECEIVED FAA CRITICISM. THE ACR IS PUTTING THE REQUIRED INFO ON THE TIRE IN LARGE CHALK LETTERS THAT WILL DISAPPEAR AFTER INSTALLATION.