AN MD90 DURING MAINT CHECK WAS DISCOVERED TO HAVE A STABILIZER UPPER LOCK MOUNT INSPECTION FITTING INSTALLED WHICH CAUSED STRUCTURAL DAMAGE.

Narrative

RECENTLY I COMPLETED A HORIZONTAL STABILIZER/JACKSCREW INSPECTION ON AN MD90 ACFT. THE OPERATION REQUIRES A RESTRAINING FIXTURE TO BE AFFIXED TO THE AIRPLANE. THE MOUNTS FOR THE RESTRAINING FIXTURE ARE UPPER AND LOWER. AFTER REVIEW; THE UPPER MOUNT SHOULD BE REMOVED BEFORE ACFT RELEASE. THE MOUNT COULD CAUSE STRUCTURAL DAMAGE. I DID NOT REMOVE THE UPPER MOUNT. I ALSO DIDN'T INSTALL THE UPPER MOUNT. IT WAS ALREADY ON THE AIRPLANE -- DUE TO LIGHTING AND ACCESS I COULD NOT SEE THE TYPICAL DAMAGE LOCATION. OF COURSE I DIDN'T KNOW THE FITTING OR THE DAMAGE WERE POSSIBLE. I BELIEVE MORE TRAINING SHOULD BE GIVEN FOR SUCH AN IMPORTANT INSPECTION. I DIDN'T KNOW THERE WAS A PROB WITH THE UPPER MOUNT BECAUSE THIS WAS MY FIRST INSPECTION. NOBODY ELSE THAT NIGHT HAD EVER DONE THE INSPECTION EITHER. I NOTIFIED MAINT TO INSPECT OUR MD80 AND MD90 FLEET FOR MORE TEST FITTINGS INSTALLED ON ACFT. CALLBACK CONVERSATION WITH RPTR REVEALED THE FOLLOWING INFO: THE RPTR STATED THE AIRPLANE CAME INTO THE MAINT CHECK WITH THE UPPER MOUNT INSTALLED BY A PREVIOUS STATION DOING THE STABILIZER INSPECTION. THE RPTR SAID THE INSPECTION IS QUITE NEW AND FEW PEOPLE WERE AWARE OF THE SPECIAL TOOLING TO LOCK THE HORIZONTAL STABILIZER FOR THE INSPECTION. THE RPTR SAID NO TRAINING WAS GIVEN ON THE INSPECTION AND TOOLING REQUIRED. THE RPTR STATED THE JOB CARD TO PERFORM THE INSPECTION IS INADEQUATE AS THE LAST STATEMENT ON THE CARD DIRECTS REMOVAL OF ALL TOOLING INSTALLED. THE RPTR SAID PROCS WERE INTRODUCED TO CORRECT THE JOB CARD WITH DIAGRAMS AND PAINT ALL REQUIRED TOOLING A BRIGHT COLOR WITH SIX FOOT STREAMERS. THE RPTR SAID THIS SOLVES THEIR PROB BUT HOW ABOUT OTHER MD90 OPERATORS?