History of Flight
On September 2, 2018, about 1336 Pacific daylight time, a Schempp-Hirth Duo Discus T motorized glider, N22XC, was destroyed when it was involved in an accident near New Washoe City, Nevada. The two pilots were fatally injured. The glider was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.
The flight was part of an informal competition (task), the goal of which was to obtain the shortest flight time between two predetermined locations. Each competitor's flight time would start when their glider flew over runway 2/20 of Truckee-Tahoe Airport (TRK), Truckee, California, and end upon reaching a predefined radius around Marine Corps Mountain War Training Center Heliport (7CL4), Bridgeport, California. There was no specific start time, the gliders departed at staggered intervals throughout the day, and any route could be taken.
The pilot of the towplane stated that the accident glider's takeoff and tow was uneventful, and the glider released after reaching an altitude of 8,000 ft mean sea level (msl), (about 2,000 ft agl) about 3 miles east of TRK over an area known locally as "Hot Rocks."
The accident glider and several other gliders flying in the vicinity were equipped with FLARM traffic awareness and collision avoidance systems. This data revealed that, after release, the accident glider began a series of climbing turns over Hot Rocks, reaching an altitude of about 10,500 ft msl. It then proceeded east on a meandering track while performing another series of climbing turns about 3.5 miles west of the summit of Slide Mountain. The last position was recorded at 1333 at an altitude of about 14,500 ft msl, 12 miles east of TRK, and 1 mile west of the 9,698-ft summit of Slide Mountain.
Another glider pilot competing in the task reported sharing a thermal with the accident glider for a few minutes beginning about 1331. He stated that they were both over the spine of the mountain just south of the peak of Mt Rose, at an altitude of about 14,000 ft msl. The accident glider appeared to be flying normally and there were no indications of distress. The pilot did not hear any radio calls from the accident glider, and a few minutes later, he flew north to the peak of Mt Rose, where he climbed to almost 16,000 ft. He reported that the lift at Mt Rose was strong, with climb rates averaging up to 10 kts.
About the time of the accident, a group of paraglider pilots were preparing to launch from an 8,700-ft-high bluff on the eastern face of Slide Mountain. Their attention was drawn to a glider traveling near the face of the slope directly to the east and above their location.
One witness stated that, as he looked up, he saw a glider performing a series of "steep back loop" maneuvers, such that he initially thought it was a remote-controlled aircraft. He watched as the glider performed another loop. During that maneuver, he started to hear a high-pitched whistling/vibrating sound, and the wings flexed upwards such that the tips almost touched each other. One of the wings then broke off, followed by a loud "cracking" sound, and the sky was filled with confetti-like pieces of white debris. He could see that the canopy was closed and watched to see if anyone attempted to bail out, but they did not.
Another witness stated that when he first saw the glider, it was passing from left to right and performed 2 or 3 full "loops" that lasted about 2 to 3 seconds each. He stated that the wings of the glider were flexing upwards aggressively throughout the maneuvers, and as it rolled out of the final loop, the left wing broke away and struck the tail.
A third witness, who was a fixed-wing pilot, stated that he looked up and saw the glider perform a series of loop-like maneuvers, which had a radius of about two wingspans. He described the maneuvers as smooth and progressive, and that the glider appeared to be under positive load throughout. On completion of the second loop, the glider rolled out and the wings appeared to flex up like "rubber" and form a "U" shape when viewed from the front. He heard a buzzing sound, and then the left wing broke away, followed by a very loud snapping sound similar to cracking timber. The glider then immediately entered into a flat spin, and white shards of debris filled the sky surrounding the glider. After the first spin rotation, the glider appeared to level off, and the witness considered the possibility that the pilot had regained control. The glider then rolled over, and the right wing failed.
Witnesses stated that they did not see indications that the engine/propeller had been extended, and none of them described seeing any evidence of smoke or vapors trailing from the glider.
Personnel Information
Rear Seat Occupant
The glider's co-owner, who occupied the rear seat, held a private pilot certificate with a glider rating. He did not hold a current medical certificate; however, the provisions of 14 CFR 61.23 notes that pilots exercising the privileges of a glider category rating are not required to hold a medical certificate.
Pilot logbooks were not available for review. Friends and acquaintances of the pilot stated that he had extensive flight experience in gliders, flew most weekends during the flying season, and had well over 1,000 hours of flight time. He had organized multiple similar tasks and was described as a "purist" who specialized in long-distance flights and held multiple records. One witness stated that the pilot flying aerobatics was "not in his DNA."
Records on file at the pilot's local soaring club indicated that his most recent flight review was completed on March 31, 2018.
Front Seat Occupant
The front seat pilot held a private pilot certificate with ratings for airplane single-engine land and glider. He did not hold a current medical certificate.
No pilot logbooks were recovered; however, he had similar levels of flight experience and time as the rear seat pilot and owned a high-performance glider that he flew regularly.
Aircraft Information
The Schempp-Hirth Duo Discus T is a high-performance, two-seat, T-tail glider constructed primarily of carbon fiber and glass fiber-reinforced composite materials. Its engine is referred to as a "sustainer" engine and is not sufficient for takeoff use. The engine/propeller combination was mounted on a pylon behind the cockpit, and the entire assembly retracted into the fuselage when not in use. The other owner stated that the accident pilot was apprehensive about using the engine, and both he and other acquaintances stated that he regularly performed off-airport landings rather than use the engine to return to the departure airport.
The glider was equipped with flight controls at both pilot stations as well as a supplemental oxygen system, which was filled to 2,000 psi the day before the accident.
Maintenance records were not recovered for the glider and presumed to have been destroyed in the fire. An invoice from the facility that performed the last maintenance event indicated that an annual inspection was competed on May 31, 2018. At that time, an avionics upgrade was performed, which included the installation of a new altimeter, air speed indicator, and integrated navigation and variometer system. According to the other owner, the glider had accrued about 300 hours of flight time at the last annual inspection.
According to the flight manual, the maneuvering speed (Va) was 97 kts. The manual stated that full deflections of control surfaces may only be applied at this speed and below, and stated, "Do not make full or abrupt control movements above this speed as the aircraft structure might get overstressed." The glider was not approved for aerobatic maneuvers.
The stall speed (Vs) with the powerplant retracted and airbrakes closed at a maximum gross weight of 1,543 lbs, was 32 kts.
The never-exceed speed (Vne) was 135 kts. The manual stated, "Do not exceed this speed in any operation and do not use more than 1/3 of control deflection."
The airbrakes may be extended up to Vne; however, the manual stated they should only be used at such high speeds in emergency or if the maximum permitted speeds are being exceeded inadvertently.
The stall recovery technique while flying straight ahead or in a bank called for "firmly easing the control stick forward and, if necessary, applying opposite rudder and aileron."
The manual-provided instructions for spin recovery stated that with a rearward center of gravity, a steady spinning motion is possible that will stop within about ¼ and ½ rotation once the appropriate recovery technique has been applied. With the center of gravity in the foremost position, a steady spinning motion is not possible, and after spin recovery the glider will usually enter a spiral dive, which is accompanied by a rapid increase in speed and acceleration. Recovery could be achieved by easing the control stick forward and applying opposite rudder and aileron. An accompanying warning stated, "When pulling out of the dive, the permissible control surface deflections at Va / Vne are to be observed!"
The maneuvering load factor limits (in units of gravity or g's) were:
- With airbrakes locked and at Va, +5.3 g, -2.65 g
- With airbrakes locked and at Vne, +4.0 g, -1.5 g
- With airbrakes extended +3.5 g (no negative limits specified)
Engineers from Schempp-Hirth estimated the speeds and g-loading that would have resulted if the glider had performed a loop with a radius of two wingspans (130 ft) over a 2-second period, as observed by one of the witnesses. Under such conditions, the glider would have needed to travel at a speed of about 240 kts, and would have endured a load of about 40 g.
With a loop radius of 165 ft, performed in 4 seconds, the speed would have been about 150 kts, and the glider would have experienced a load of about 12.5 g.
The flight manual detailed a series of steps for opening the canopy during emergency situations, and stated as soon as it is opened, it will be torn from its hinges, and carried away by the airstream.
Meteorological Information
Pilots flying the task that day all reported good soaring conditions, including strong lift, good visibility, and minimal turbulence.
The National Weather Service (NWS) Surface Analysis Chart for 1400 depicted a weak pressure gradient over the region with several thermal low-pressure systems. No defined frontal boundaries were depicted over the western United States during the period.
Upper air charts indicated dry conditions and absence of clouds over the area. The NWS Winds and Temperature Aloft Forecast for Reno indicated light and variable winds at 6,000 ft, winds from 130° at 7 knots at 9,000 ft, and winds from 190° at 11 knots at 12,000 ft.
The closest upper air sounding from the NWS Reno at 1700 indicated strong thermal activity from the surface through 17,000 ft, with a low-level wind maximum near 14,000 ft with wind from 250° at 21 knots. Analysis of the sounding profile indicated a high probability of moderate turbulence at 12,000 ft or immediately below the low-level wind maximum with an 8.1 knot/1,000 ft vertical shear.
At the time of the accident, the altitude and azimuth of the sun when viewed from Slide Mountain would have been about 58° and 182°, respectively.
Wreckage and Impact Information
The wreckage was located on the lower eastern flank of Slide Mountain at an elevation of about 6,630 ft msl, and 2.5 miles east-southeast of the last FLARM-recorded position. The glider ignited a fire upon impact, which eventually burned a 58-acre area of brush uphill to the west. The main wreckage comprised the fuselage, engine assembly, right wing, and vertical stabilizer fragments, all extensively damaged by fire. A secondary 1,500-ft-long debris field spread northwest from the main wreckage, outside of the burn area, and contained the front headrest and an outboard section of the left wing, along with plexiglass canopy and control surface fragments. The furthest identifiable piece was a section of the horizontal stabilizer upper skin, 1,000 ft above the main wreckage.
The wreckage was examined by an NTSB airworthiness group, including a team of investigators and a representative from Schempp-Hirth.
Examination of the left inboard wing revealed fracture and failure features consistent with overload. The left outboard wing and inboard wing sections were located in the debris field with no fire damage. The elevator trim locking control rod was found at the midrange position. The airbrake control system appeared to have complied with an airworthiness directive. The left airbrake had separated from the wing, with damage consistent with the airbrake separating aft while extended. The engine remained attached to its pivot assembly and was in the retracted position at impact.
Burnt remnants of the canopy frame were identified, with hinge rods and locking assembly bent in several locations. Both seat buckles and remnants of two parachutes were identified. There was no evidence of bird remnants on any recovered components. Electrical arcing damage was observed to multiple strands of 10 AWG wire in the area of the engine bay and pylon assembly.
Additional Information
A video camera operated by the "ALERTWildfire" university consortium captured images of the accident. The camera was located on the top of Slide Mountain at an elevation of 9,590 ft. During a 3-minute period between 1336:02 and 1338:58, the camera captured images of multiple pieces of debris passing from top to bottom on the right side of its field of view.