On August 6, 2019, a CESSNA 208 B was involved in an aviation accident near Mayo, Canada. 2 people were killed. This summary draws on records from NTSB; 12 related events involving the same aircraft type or operator are linked below.
The NTSB has appointed a U.S. Accredited Representative to assist Canada's investigation of a Cessna 208 accident that occurred on August 6, 2019.
Notification and International Cooperation
The government of Canada has notified the National Transportation Safety Board (NTSB) of an accident involving a Cessna 208 airplane that occurred on August 6, 2019. In accordance with ICAO Annex 13, the NTSB has appointed a U.S. Accredited Representative to assist the government of Canada's investigation.
Investigation Lead
All investigative information regarding the accident will be released by the government of Canada. The Transportation Safety Board of Canada (TSB) is the lead investigating authority.
Contact Information
The Transportation Safety Board of Canada can be reached at:
Address: 200 Promenade du Portage, Place du Centre, 4th Floor, Hull, Quebec K1A 1K8, Canada
An X-AIR HAWK ultralight crashed in Chonburi, Thailand, killing the pilot and injuring a passenger. The accident was caused by deteriorated wing fabric and…
A Challenger II Special ultralight aircraft (U-B23) landed off-runway at Pai Airport, Mae Hong Son, on September 17, 2024, due to a gust of wind. No injuries…
The Polish aviation safety authority is investigating a serious incident involving an AT-3R100 aircraft that occurred on September 2, 2024. The investigation…
A SZD-48-3 glider suffered damage when its left wing struck a ground obstacle during a low final approach at EPWK on June 20, 2025. The pilot was uninjured.
A 39-year-old skydiver died after a hard landing near Leszno on May 1, 2026. The PKBWL preliminary report indicates the fatal impact resulted from a late,…
A student pilot crashed an SZD-50-3 Puchacz glider into the airfield fence during a solo training flight on June 6, 2026. The pilot was uninjured, but the…