No fatalities

9 Jun 2008: Cessna 172M — Bel-Air International — Byron, CA

Byron, CA, United States

On 9 Jun 2008, a Cessna 172M operated by Bel-Air International was involved in an aviation accident near Byron, CA. No fatalities were reported. Investigators recorded the probable cause as: The student pilot's failure to maintain directional control during landing rollout. This summary draws on records from NTSB; 13 related events involving the same aircraft type or operator are linked below.

SourcesNTSBPrimary reportUpdated 1778583330Data APIEditorial standards

A student pilot veered off runway 30 during rollout after applying right rudder/brakes, losing directional control. The airplane skidded into a grassy field and struck an upsloping ravine, causing substantial damage.

Incident Overview

A student pilot was landing on runway 30, which measures 4,500 feet in length and 100 feet in width. During the rollout, the airplane began veering toward the right side of the runway. The student reported that he "stepped on the right rudder/brakes" and subsequently "lost directional control."

Evidence and Sequence

An estimated 30-foot-long skid mark was observed on the runway, leading off its right side. The airplane then entered a grassy open field and came to rest after colliding with the upsloping side of a ravine. The emergency locator transmitter (ELT) activated following the impact.

Pilot Experience

The student reported a total of 72 hours of flight time, of which 3.2 hours were in solo flight.

Aircraft Damage

Airplane recovery personnel reported to the National Transportation Safety Board investigator that the right wing's outboard rib was demolished, approximately 1½ feet of adjacent leading edge skin was crushed inward, and the firewall was buckled.

Contributing factors

Causes

Directional control — Not attained/maintained

Other contributing factors

Airport facilities/design