No fatalities

25 Aug 2012: CIRRUS DESIGN CORP SR20 — Watkins, CO

Watkins, CO, United States

On 25 Aug 2012, a CIRRUS DESIGN CORP SR20 was involved in an aviation accident near Watkins, CO. No fatalities were reported. Investigators recorded the probable cause as: The pilot did not maintain control of the airplane while landing in gusty wind conditions. This summary draws on records from NTSB; 12 related events involving the same aircraft type or operator are linked below.

SourcesNTSBPrimary reportUpdated 1778583330Data APIEditorial standards

During a third touch-and-go landing on runway 35, the aircraft experienced a stall warning at about 200 feet, dropped, and impacted the runway hard. After bouncing, a go-around attempt failed, resulting in a nose-low impact that separated the nose landing gear and damaged the propeller and firewall. No mechanical anomalies were found.

Accident Details

The pilot was performing touch-and-go landings on runway 35. During the final approach for the third touch-and-go, the pilot felt a buffet and anticipated gusting wind conditions at touchdown.

Sequence of Events

Approximately 200 feet above the ground, the stall warning horn sounded briefly, and the airplane "dropped straight down." The aircraft impacted the runway hard and bounced several times. The pilot added power in an attempt to go around; however, the airplane did not respond and impacted the runway again in a nose-low attitude.

Damage and Inspection

During the accident sequence, the nose landing gear separated, the propeller was damaged, and the firewall wrinkled. The Federal Aviation Administration inspector who responded stated that there were no mechanical anomalies with the airplane.

Contributing factors

Causes

Pilot

Other contributing factors

Effect on operation