Accident Details
On October 24, 2013, at about 1000 Pacific daylight time, a Piper PA-28-180, registration N30865, was substantially damaged when it impacted trees and terrain during a forced landing following a loss of engine power near Big Creek, California. The private pilot, the sole occupant, was seriously injured. The airplane was owned by the pilot and another individual and operated under 14 Code of Federal Regulations Part 91. No flight plan had been filed for the personal cross-country flight. The airplane had departed Bishop, California, approximately one hour before the accident, with its planned destination being Fresno, California. Visual meteorological conditions prevailed.
According to the Federal Aviation Administration, the pilot reported to an air traffic controller that the engine lost oil pressure and then lost power. The pilot performed a forced landing into trees at an elevation of about 8,200 feet in the mountainous terrain of the Sierra National Forest. Examination of photographs taken at the accident site by recovery personnel showed that the airplane's wings, fuselage, and empennage were bent and wrinkled.
Engine Examination
After the airplane was recovered to the facilities of Plain Parts in Pleasant Grove, California, it was examined under the supervision of a National Transportation Safety Board investigator on December 5, 2013. The examination revealed engine oil coating the left rear side of the engine and extending down the left side of the fuselage. The source of the oil was a fractured fitting at the oil pressure gage/sending unit port located on the left side of the engine's accessory case cover. An oil pressure sending unit, which appeared to be new, had been installed at this location and was found dangling by its electrical wiring harness. The sending unit and attached fittings measured about 2.5 inches in length, and the sending unit was not supported in any fashion. The engine case exhibited a bulging signature between the number 2 and number 4 cylinders consistent with an internal mechanical malfunction due to oil starvation. No further internal examination of the engine was performed.
It was noted that the engine had been modified by the installation of an electronic fuel injection and ignition system manufactured by Electronic Fuel Injection and Ignition of Upland, California. According to the company's website, its systems are intended for use on experimental category aircraft.
Maintenance History
The most recent maintenance entry in the engine's maintenance logbook was made on July 10, 2013, by the co-owner of the airplane (who was not an FAA-certified mechanic) at a recording tachometer time of 3,446.01 hours. The logbook entry stated: "annual insp. completed, oil and filter, replaced all cylinders and pistons with first run Lycoming O/H, EFII electronic ignition." There was no record in the logbook of the installation of a new oil pressure sending unit.
During a telephone interview conducted by the NTSB investigator-in-charge, the co-owner reported that the pilot (who also was not an FAA-certified mechanic) told him that he had installed the oil pressure sending unit just before the accident flight.