No fatalities

10 Jun 2018: CESSNA 170 B — Benson, AZ

Benson, AZ, United States

On 10 Jun 2018, a CESSNA 170 B was involved in an aviation accident near Benson, AZ. No fatalities were reported. Investigators recorded the probable cause as: The pilot’s failure to maintain directional control during landing. This summary draws on records from NTSB; 12 related events involving the same aircraft type or operator are linked below.

SourcesNTSBPrimary reportUpdated 1778583330Data APIEditorial standards

During landing roll, a tailwheel-equipped airplane veered left and bounced. Pilot's rudder corrections and go-around attempt led to a ground loop, resulting in substantial right wing damage.

Accident Sequence

During the landing roll, the pilot reported that the tailwheel-equipped airplane veered to the left and began to bounce. He applied right rudder correction, which quickly turned the airplane right towards the centerline. He then applied left rudder to realign with the runway heading. Increasing the engine power setting to full to perform a go-around, the airplane, on its third bounce, ground looped to the left. The right wing impacted the ground and the airplane came to rest on its right side with the wing at a 90° angle.

Pilot Report

The pilot stated that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation.

Weather Information

The automated weather observation system located on the airport reported that, about 15 minutes before the accident, the wind was light and variable at 2 knots, gusting to 5 knots. The airplane landed on runway 28.

Damage

The airplane sustained substantial damage to the right wing.

Contributing factors

PilotDirectional control — Not attained/maintained