No fatalities

Tailwheel Airplane Stalls During Go-Around After Landing Overshoot

Dillingham, AK, United States

On June 5, 2019, a Cessna 170 B was involved in an aviation accident near Dillingham, AK. No fatalities were reported. Investigators recorded the probable cause as: The pilot's improper landing flare, which resulted in a long landing and subsequent loss of directional control, and his subsequent failure to attain sufficient altitude to clear trees during an attempted go-around. This summary draws on records from NTSB; 12 related events involving the same aircraft type or operator are linked below.

SourcesNTSBPrimary reportUpdated 2026-08-03Data APIEditorial standards

A tailwheel-equipped airplane stalled and struck trees during a go-around after overshooting the landing point on a remote unimproved airstrip, resulting in substantial damage.

Accident Overview

A pilot flying a tailwheel-equipped airplane reported an accident during a landing attempt at a remote unimproved airstrip. The pilot overshot the intended touchdown point by approximately 150 feet during the landing. As the airplane continued its landing roll, it veered to the right side of the runway, prompting the pilot to initiate a go-around.

Go-Around and Stall

During the initial climb of the go-around, the pilot observed that the airplane would not clear trees ahead. In response, the pilot pulled up abruptly, which caused the airplane to enter an aerodynamic stall. The left wing then descended and struck trees, and the airplane spun 180 degrees before impacting the ground.

Damage and Mechanical Status

The airplane sustained substantial damage to both wings, the empennage, and the fuselage. The pilot reported that there were no mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Contributing factors

PilotAltitude — Not attained/maintainedLanding flare — Not attained/maintainedDirectional control — Not attained/maintainedEffect on operation

Frequently asked questions

What happened in the 5 Jun 2019 Cessna 170 B accident near Dillingham, AK?

A tailwheel-equipped airplane stalled and struck trees during a go-around after overshooting the landing point on a remote unimproved airstrip, resulting in substantial damage.

Were there any fatalities in the 5 Jun 2019 Cessna 170 B accident?

No fatalities were recorded in this accident.

What aircraft was involved and where did it happen?

The accident on 5 Jun 2019 involved a Cessna 170 B, at Dillingham, AK.

What was the probable cause of the accident?

The pilot's improper landing flare, which resulted in a long landing and subsequent loss of directional control, and his subsequent failure to attain sufficient altitude to clear trees during an attempted go-around.