Casualties unknown

1990-03-16: Cessna 152 (N4590P) — Aeromech — Albuquerque, NM

Albuquerque, NM, US

On March 16, 1990, a Cessna 152 (registration N4590P) operated by Aeromech was involved in an aviation accident near Albuquerque, NM. Investigators recorded the probable cause as: THE FUEL EXHAUSTION INDUCED POWER LOSS. This summary draws on records from the U.S. National Transportation Safety Board (NTSB) historical archive; 8 related events involving the same aircraft type or operator are linked below.

Sourcesthe U.S. National Transportation Safety Board (NTSB) historical archivePrimary reportUpdated 1781061362Data APIEditorial standards

A pilot reported engine failure three hours after takeoff. After restart attempts failed, he performed a forced landing in rough terrain. The nose gear was torn off, and the aircraft came to rest inverted. Investigation revealed both fuel tanks contained only traces of fuel.

Incident Summary

Approximately three hours after departure, the engine of the aircraft quit. The pilot stated that he was able to restart the engine but could not keep it running. He then elected to perform a forced landing.

Forced Landing

The pilot initially planned to land on a dirt road. However, upon observing cows on the road, he chose to land in rough terrain instead. The area consisted of rolling hills covered with brush. During touchdown, the nose gear was torn off, causing the aircraft to nosed over and come to rest in an inverted position.

Investigation Findings

A postaccident investigation was conducted. It revealed that both fuel tanks contained only traces of fuel. No further details were provided regarding the engine failure or fuel system.

Investigation report by the U.S. National Transportation Safety Board (NTSB) historical archive. Original record: https://carol.ntsb.gov/event/20001212X22701. This page is a structured re-presentation; facts and quotes are in the National Transportation Safety Board (NTSB), United States.