No fatalities

5 Mar 2016: AEROPRO CZ A220 — Canton, TX

Canton, TX, United States

On 5 Mar 2016, an AEROPRO CZ A220 was involved in an aviation accident near Canton, TX. No fatalities were reported. Investigators recorded the probable cause as: The pilot's failure to maintain directional control during an aborted landing, which resulted in a runway excursion and a collision with trees. This summary draws on records from NTSB; 12 related events involving the same aircraft type or operator are linked below.

SourcesNTSBPrimary reportUpdated 1778583330Data APIEditorial standards

A tailwheel airplane impacted trees during an aborted landing after a gust of wind caused a bounce and subsequent leftward deviation from the runway.

Incident Summary

A pilot of a tailwheel-equipped airplane reported that during the landing flare, a gust of wind caused the aircraft to bounce upon touchdown. During the subsequent landing roll, the airplane began moving to the left. The pilot applied power to initiate a go-around, but the airplane continued to veer left, departing the runway surface. The aircraft then struck trees located approximately 115 feet to the left of the runway.

Aircraft Damage

A postaccident examination revealed substantial damage to both wings and the fuselage.

Pilot Report

The pilot reported that there were no mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Contributing factors

Causes

Directional control — Not attained/maintainedPilot

Other contributing factors

Ability to respond/compensate